Resmed Tubing Wrap

The ResMed tubing wrap with micro-fiber filling maximizes heat retention along the air tube, enhancing patient comfort and reducing the effects of rainout. Soft and smooth, the tubing wrap slides easily across the bedding, reducing drag and noise and improving the overall therapy experience. Easy to put on and remove Easy to clean Improved insulation Will not catch on bed sheets.

Tubing wraps are intended to reduce condensation and temperature loss in air tubing. There are two tubing wraps:

• Standard for use with standard air tubing 6’ (1.8 m) or 6’ 6” (2 m) long, 0.7” (19 mm) inner diameter.

• SlimLine for use with SlimLine air tubing and  ClimateLine heated air tubing 6’ (1.8 m) long, 0.6“ (15 mm) inner diameter.

Standard 6’ (1.8 m) Tubing Only To fit the tubing wrap to the Standard 6’ (1.8 m) tubing, the tubing wrap must be shortened. The free end of the tubing wrap has two Velcro® tabs on its internal surface. To shorten the tubing wrap, fold the end of the wrap so the two velcro tabs are fastened together. You may now fit the tubing wrap as described below.

1. Fully unzip the tubing wrap and unfasten both Velcro straps.

2. Open the tubing wrap out and lay it down with the inside facing up.

3. Pass one end of the air tubing through the closed end of the tubing wrap until the rubber cuff is poking out.

4. Keeping the air tubing cuff in position, zip the tubing wrap completely around the air tubing.

5. Fasten both of the Velcro straps around the tubing wrap.

Ensure that the tag end of the zip (all tubes) and the zipper pull tab (6’ tubes only) are secured under the straps.